Beginners Guide DVD to MK TOOL
Guide to MK Tool DVD

Beginners Guide DVD to MK TOOL

On sale $29.00
In Stock
If you are just getting started with Mikrokopter Boards, you will save time and avoid headaches with these DVDs. They use close-up screen video and clear, simple instructions to teach you all you need to know about setting up the software and hardware for your computer to communicate with MK boards.

The DVD's also cover detailed guidance for installing the MK Tool, updating the MK board's firmware, assigning copter controls to radio control channels, explaining altitude hold, GPS position hold, come home, and how to setup the parameters for these features. They also explain the Mikrokopter safety features of failsafe and emergency come home.

DVD #1:
1. Introduction
2. Virtual COM Ports
3. Testing the MKUSB Adapter
4. Connecting to the MK Boards
5. Intro to MK Subsystems
6. Intro to MK Tool
7. Updating the MK Boards Software
DVD #2:
1. Assigning the Channels
2. Potentiometers
3. Motor Safety Switch
4. Parameter Sets
5. Altitude Hold["AH"]
6. Position Hold["PH"]
7. Come Home["CH"]
8. Assigning AH/PH/CH Switches
9. Carefree Mode["CF"]
10. Mixer
11. Minimum Voltage Alarm
12. Tx Signal Loss[no GPS/Navi]
13. Tx Signal Loss[with GPS/Navi]
14. Failsafe Channel Assignment

Standard definition NTSC two DVD set. Total run time: 2 hours & 24 minutes.

CineStar still images, opening and closing video: Copyright 2013 by Quadrocopter LLC, Freefly Systems, and Johnson-Laird Inc.
4 Stars
Guide to MK tool
This product is a must for anyone who is going operate a very expensive machine such as this cinestar, it's a good starting point MK took is very helpful and very informative but I feel that there is one section that should be added such as a fine tuning section for "expert mode" and troubleshooting the copters gimbals. As well as the flight characteristics for the gyros.
Did you find this helpful? 
Reviewed by:  from Vancouver . on 2/26/2014
5 Stars
I found this DVD a huge help for introducing me to MK Tool. It has already saved me money. I wasn't able to get MK Tool running on the Mac. Thought it was an problem with an old version of Parallels and was about to buy a new version. With Andy's clear instructions on the DVD I was able to get it working. The content of the DVD is well presented and easy to learn from. It has saved me many hours looking for answers on forums.
Did you find this helpful? 
Reviewed by:  from Australia. on 7/29/2013

Beginners Guide DVD to MK TOOL


Reward Points

1 point(s) will be rewarded to you when you buy this item.

Related Items


Recently Viewed Items

Browse By Category